Vanner 20-1000TUL Owner's Manual download pdf (Page 11)

VANNER

Incorporated

Owner’s Manual

LifeStar Owner’s Manual - 11 -

Section 7: Operating the 20-1050CUL-DC Ambulance Power Module

Use the following instructions to operate the 20-1050CUL-DC Inverter.

Step 1: Install the 20-1050CUL-DC Unit.

Completely install the inverter and charger using the instructions provided in Section 2 of this manual.

Step 2: Start the vehicle.

Step 3: Turn switches on.

Turn on the Module Disconnect Switch and the Inverter Remote Switch.

Step 4: Verify Power.

Apply an AC load, such as a shop light or drill. Verify operation.

Step 5: Apply shore power

Turn vehicle off, apply shore power to the 20-1050CUL-DC/Ambulance shore line connection. After shore

power has been connected one of the Chargers LED’s will light or flash. Push the ON-OFF/RESET

Inverter Switch to the ON position. The inverter lamp will flash, indicating that the inverter is standing by.

Step 6: Observe Transfer Switch.

Remove the shore line connection from the emergency vehicle. The unit will automatically switch to

Inverter mode and operate the AC load using battery power. When shore power is restored, the unit

examines the AC input for five seconds and then switches the loads back to run directly from AC shore

power.

1 2 ... 6 7 8 9 10 11 12 13 14

No comments

Vanner 20-1000TUL Owner's Manual Page 11